DRAWING MACHINERY, INTERMEDIATE 

#99C-5139 Vaughn Model 6/7 HIV Intermediate Wire Drawer; 6 block, 7 die; start size: .142-.130" (3.6-3.3mm); finish: .045"-.030" (1.1mm-.7mm); 1st block double deck 10/14"; blocks 2-5:14; finish block: 16"; 6 x 15HP DC Motors; 1500 FPM approx.; water cooling; 10HP blower motor; Mentor-controls Tecnique SCR DC controls
#99C-5163

Steinhilber Eng. Intermediate-Fine Wire Drawing Lines; 9 to 10 die, 14% area reduction (approx.), enter .120” – finish .062” (3.0-1.4mm), enter .105” – finish .044” (2.7-1.1mm), enter .072" - finish .0274"; 1018-1027-1023 carbon, 2 steel band – 4 groove draw cones, 3000 FPM approx., Recirculating coolant system, 150 HP DC Reliance motor: 1150-2000 RPM, 480V-60-3, Inline die stringer + pointer, Dual 6 groove belt drive drive-pullout capstan, 22” up to 36” Steinhilber traversing spooler, 2 machines available

 

Note: photo of spooler may not be exact, but similar.  Choice of spoolers - See Ref. 633C-2041 or Ref. 633-2042 - "Coilers, Spoolers, Winders"
#99C-5179 Ernst-Koch Intermediate- Fine Wire Drawing Line; intermediate max wire start: 4 to 5mm (.157"-.196") double deck bullblock; 12"/16" x 15HP; fine wire start: 2.5 to 2.8mm (.098"-.110"); finish: 0.25-1.20mm (.010"-.047"); Ernst Koch Model GDZ-125-1987; 19 to 21 die; wet draw; 4 cone; 60HP DC; 3600 FPM approx.; Take-up barrel pack coiler: 16" line block capstan: barrel 20"x30"H; Alan Bradley controls

 

#99C-5180 Ernst-Koch Intermediate- Fine Wire Drawing Line; intermediate max wire start: 4 to 5mm (.157"-.196") double deck bullblock; 12"/16" x 15HP; fine wire start: 2.5 to 2.8mm (.098"-.110"); finish: 0.25-1.20mm (.010"-.047"); Ernst Koch Model GDZ-128-1989; 19-21 die; wet draw; 4 cone; 60HP DC; 3600 FPM; Morgan Koch Vertical Spooler: 24" flange; Spectrum PLC controls

 

 

Gavlick Machinery Corporation
100 Franklin Street, Bristol, Connecticut 06010, USA
Phone: 860-589-2900      Fax: 860-589-0863
e-mail: sales@gavlick.com    home: www.gavlick.com